-
After 20+ years it's time to pass the torch. If you are interested in acquiring this forum please contact support@cv-performance.com for details. Any spam will be reported and blocked.
-
Welcome to Bike Talk, a forum for all bikers and motorcycle enthusiasts. If you are new to Bike Talk, be sure to register for free and join the conversation.
There's always someone around willing to help out with questions or give a friendly wave back. All Harley and metric riders are welcome.
Bike Talk motorcycle forum
«
»
Mar
04
Can I take directions from google maps and program them into the GPS, or do I have to enter a specific destination?
Mar
04
2005 FXSTI
I suspect this might be a EFI problem.
What happens is at times the engine completely cuts out. The starter motor will turn over fine but the engine does not start. The engine is more prone to doing this when cold, when fully warmed up it has cut briefly a couple of times, one second or two, then starts again. When cold it cuts out, refuses to restart. Leave it five minutes and try again and it will probably start. Leave another ten and it starts fine.
I'd be more inclined to suspect fuel lines or an electronic fault if the same things happened when the engine was hot or cold, hence me thinking EFI.
Anyone else come across this problem?
Thanks in advance.
Ashley
I suspect this might be a EFI problem.
What happens is at times the engine completely cuts out. The starter motor will turn over fine but the engine does not start. The engine is more prone to doing this when cold, when fully warmed up it has cut briefly a couple of times, one second or two, then starts again. When cold it cuts out, refuses to restart. Leave it five minutes and try again and it will probably start. Leave another ten and it starts fine.
I'd be more inclined to suspect fuel lines or an electronic fault if the same things happened when the engine was hot or cold, hence me thinking EFI.
Anyone else come across this problem?
Thanks in advance.
Ashley
Mar
04
Mar
04
Anybody out there know where to place the magnet to set the pattern? I can't seem to find my instruction sheet or locate the instructions from their web site.
TY........Mike
TY........Mike
Mar
03
Anyone out here have a outlet for the remover besides Jim"s, $315.00 seems a little pricey.
Tom
Tom
Page 406 of 2361
XenPorta
© Jason Axelrod from 8WAYRUN.COM